Chapter 11 QoS
GS-1524/GS-1548 User’s Guide
75
The following table describes the labels in this screen.
11.4.6 IP Address Based QoS
You can configure the Switch to assign a higher priority to packets coming into the
Switch from specific IP addresses. Select IP Address Based QoS in the QoS
Enhancement Setting screen to view the following screen.
Figure 43 IP Address Based QoS
Table 20 ToS Based QoS
LABEL DESCRIPTION
Mode Select ToS Based QoS to specify mapping rules between ToS priority and
IEEE 802.1p priority for incoming packets on the Switch.
Change
Priority
Configure the following:
• TOS - Select the ToS priority for which you want to change a priority
mapping.
• Priority - Select the IEEE 802.1p priority you want to assign to the
packets with the ToS priority you specified in the TOS field.
Click Change to view your changed settings.
Note: The changes are not applied until you click Apply Change
Settings.
TOS,
Priority
This is a summary table of your ToS priority to IEEE 802.1p priority
mappings. The TOS column indicates the ToS priority of the incoming packets
and the Priority column indicates what IEEE 802.1p priority gets assigned to
those packets.
Apply
Change
Settings
Click this when you have reviewed the changes you want to make and you
want to save them to the Switch’s memory.
