Chapter 13 Link Aggregation
GS1510 Series User’s Guide
80
The following table describes the labels in this screen.
Table 20 LACP
LABEL DESCRIPTION
State Select Enable from the drop down box to enable Link Aggregation Control
Protocol (LACP).
Select Disable to not use LACP.
System
Priority
LACP system priority is a number between 1 and 65,535. The switch with
the lowest system priority (and lowest port number if system priority is the
same) becomes the LACP “server”. The LACP “server” controls the
operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number,
the higher the priority level.
Group LACP Select a trunk group ID and then select whether to Enable or Disable
Group Link Aggregation Control Protocol for that trunk group.
Apply Click Apply to save your changes to the Switch.
Refresh Click Refresh to begin configuring this screen afresh.
Group ID The field identifies the link aggregation group, that is, one logical link
containing multiple ports.
LACP State This field displays if the group has LACP enabled.
