NetAtlas Enterprise Ethernet Switch Manager
7
7 Using SNMP
Check that you are using SNMP Version 2c (SNMPv2c). If you are not
using SNMPv2c, you must uninstall any previous versions and install
SNMPv2c. Refer to RFC 1901 for more information on SNMPv2c.
Follow this procedure to use SNMPv2c.
1 Right-click the Device icon and select
Properties.
2 Click the Access tab.
3 Set the specified fields in the Map
Object Properties screen exactly as
shown in the figure.
Note: For security purposes, it is
strongly recommend to change
the Read Community and
Read/Write Community
defaults.
Write down this information in a secure place so you will not
forget it later!
4 Click OK. After the device has been
found, the icon and label appear in
the network manager view window.
5 Right-click on the device icon to view
a set of SNMPc network manager
shortcuts. Click Properties to verify
the information you entered in the
previous step.
6 Make sure the PostgreSQL database
is running. PostgreSQL should start
automatically when you start
Windows. If it does not, click Start
(or start), Programs, PostgreSQL
8.0 and then click Start service.
EMS_Switch_V1-01.fm Page 7 Friday, September 30, 2005 3:20 PM
