ES-2048 User’s Guide
Chapter 30 Configure Clone 209
CHAPTER 30
Configure Clone
This chapter shows you how you can copy the settings of one port onto other ports.
30.1 Configure Clone Settings
Cloning allows you to copy the basic and advanced settings from a source port to a destination
port or ports. Click Management, Configure Clone to open the following screen.
Figure 105 Configure Clone
The following table describes the labels in this screen.
Table 69 Configure Clone
LABEL DESCRIPTION
Source/
Destination
Port
Enter the source port under the Source label. This port’s attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports
which are going to have the same attributes as the source port. You can enter
individual ports separated by a comma or a range of ports by using a dash.
Example:
• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
• 2-6 indicates that ports 2 through 6 are the destination ports.
Basic Setting Select which port settings (you configured in the Basic Setting menus) should be
copied to the destination port(s).
