ES-2108 Series User’s Guide
222 Chapter 32 Configuration Mode Commands
32.4.4.1 no trunk
Syntax:
no trunk <T1|T2>
no trunk <T1|T2> lacp
no trunk <T1|T2> interface <port-list>
where
An example is shown next.
• Disable trunk one (T1).
• Disable LAPC on trunk two (T2).
• Remove ports one, three, four and five from trunk two (T2).
32.4.4.2 no port-access-authenticator
Syntax:
no port-access-authenticator
no port-access-authenticator <port-list> reauthenticate
no port-access-authenticator <port-list>
where
An example is shown next.
• Disable authentication on the switch.
• Disable re-authentication on ports one, three, four and five.
• Disable authentication on ports one, six and seven.
<T1|T2>
= Disables the trunk group.
<T1|T2> lacp
= Disables LACP in the trunk group.
<T1|T2> interface
<port-list>
= Removes ports from the trunk group.
sysname(config)# no trunk T1
sysname(config)# no trunk T2 lacp
sysname(config)# no trunk T2 interface 1,3-5
= Disables port authentication on the switch.
<port-list>
reauthenticate
= Disables the re-authentication mechanism on the listed port(s).
<port-list>
= Disables authentication on the listed ports.
