Hedge Trimmer
WG205E WG206E
WG207E WG208E
98
damaged area could cause electrical shock resulting in
serious injury.
If the supply cord is damaged, it should be replaced by
a local approved Service Centre.
Take care not to expose this tool to rain.
6. USING THE SHOVEL (See Fig. I) (WG208E)
To prevent debris from falling into the area which has
yet to be cut or other unintentional places, you can fit
the shovel towards the cutting side, then follow Fig G~
Fig H cutting sequence to cut.
MAINTENANCE
CLEANING
Disconnect from mains electrics supply. Using a soft
brush-remove debris from all air intakes and cutting
blade.
Wipe over surface of your Hedge trimmer with a dry
cloth.
WARNING: Never use water for cleaning your
Hedge trimmer. Do not clean with chemicals,
including petrol, or solvents as this can damage your
hedge trimmer.
LUBRICATING THE CUTTING BLADE
For easier operation and longer life, lubricate the
cutting blades before and after each use. Before
lubricating, make sure your Hedge trimmer is
disconnected from the mains electricity supply. Apply
the oil so that it runs between the two blades.
Your trimmer should be stopped, disconnected and
oiled occasionally during use.
AT THE END OF THE CUTTING SEASON
Clean your Hedge trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the Hedge trimmer for any worn or
damaged parts.
TO STORE YOUR HEDGE TRIMMER
Store the hedge trimmer in a secure, dry place out of
the reach of children. Do not place other objects on top
of the machine.
I
