7.
8.
9
10
11
12
13
14
15.
Remove the hood and start all four screws in the center Of
the narrow neck of the keynole slot marked on the cabinet
bottom. See Figure 2.
Remove proper venting knockout. If 7” (17.8 cm) round
vertical venting, entire top knockout including rectangular
portjon must be removed. The best performance from your
hood, with most air taken from the kitchen and when the
hood IS most quiet. comes when you top vent with 7” round
duct pipe as shown In Figure 3.
FOR RECTANGULAR VENTING: There are predrilled
holes on hood so you can attach damper to hood with
small sheet metal screws Included.
lnslall proper ductwork. For round vented installations. a
round damper should be placed In the ductwork to prevent
air Infiltration.
Lift the hood Into posttlon simultaneously feeding the
electrlcal wire lhrough the knockout
TIghten four mounting screws to secure hood to cabinet.
Be sure the screw heads are in the narrow neck of the
keyhole slot
Complete electrical wlrlng In the junction box according
to the Natlonal Electrical Code and applicable local codes.
NOTE. This unit must be permanently grounded.
Replace juncllon box cover
Seal holes around ventllatlng pipe and wiring passing
lhrough celling or outside wall with caulking or Insulation
lo prevent heat loss
Be sure that damper which IS supplied with this model is
properly Installed. (See Figures 3,4. 8 5).
FOR VENTLESS
INSTALLATION
1
To convert your range hood to ventless, remove the
discharge grill shown In Figure 6 by pulling with fingers.
Remove the metal back seal from behind the louver.
2 Replace discharge grill and secure with plastic rivets by
pushing with thumb
.3. Follow Instructtons under “Vented Installattons” for wiring
and mounting Omit ductwork preparations
3. Install charcoal falter from ventless kit behind aluminum
filter. (See Figure 7)
LIGHT LENS
rDlSCHAF?GE GRILL
FIG. 6
NOTE:
A. For round vertical venting, remove the entire top
knockout including the rectangular portion.
B. For rectangular vertical venting, remove the 3%” x
10” rectangular knockout only.
/
JUNCTION BOX J
COVER
n
CHARCOAL FILTER
UMINUM
FILTER
FIG. 7
Page 3
