5. Turn
the Load Size Selector to the settlng that
corresponds with the size of your wash load.
l
To change the load size setting after the washer
has started to fill, turn the Selector to the desired
new setting.
l
Depending on your model, your washer has either
of the following load size settings:
tW0
four
- Small
-Extra Small
- Large -Small
-Medium
- Large
6. Select a wash-rinse temperature with the Tem-
perature Selector. Match the water temperature
with the type of fabric and soils being washed.
l
See page 14 for water temperature guidelines.
l
Depending on your model, your washer has either
of the following wash-rinse temperatures:
three four
- cold-cold
- cold-cold
-warm-cold
-warm-cold
- hot-cold
-hot-cold
-warm-warm
l
Set the Temperature Selector to Warm/Warm or
to Warm/Cold (depending on your model).
Water temperature adjustment:
Adjust water temperature as follows:
l
Wash water: Adjust faucets for wash temperature
prior to the fill for wash.
l
Rinse water: Adjust faucets for temperature prior
to fill for rinse.
7. Turn Cycle Selector Knob to the desired setting.
See page 8.
8. Push the StarVPause button to start washer.
l
The Cycle Selector Knob will NOT rotate as the
cycle progresses.
l
The Cycle Status Lights indicate the operation
being performed within the cycle.
l
When the cycle is complete, all Cycle Status
Lights will be Off.
NOTE: Once a cycle has been started, the Cycle
Selector Knob MUST be turned to Off before a new
cycle can be selected.
Temperatum
Wuh
mm
I
I
W”k l
Rln” 0
Find 8phlo
Cycle stllul
7
