3
MAINTENANCE (cont'd)
• Disconnect batteries before working with the electrical system.
• When checking the hydraulic fluid level, make certain that the unit
is fully lowered and on a level floor. Remove the filler cap and
check the level of the fluid. Use a top quality hydraulic fluid. Do not
use hydraulic brake fluid.
• Before leaving the unit, stop the unit, lower the forks fully, turn off
the power, and remove the key.
• Before working on the unit, lower the forks fully, check that the
brake is working properly, turn off the power, and restrain the unit
using chocks or other restraining devices.
PARTS IDENTIFICATION
REAR FRAME
PART NO.
GB/T818/2000
WP-200A-000006
WP-200A-030008
GB5782-86
GB93-1987
GB97.1-85
WP-200A-000005
WP-200A-030000
GB/T70.1-2000
GB93-1987
GB/T894.2-1986
GB/T276-94
WP-200A-000007
ITEM NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
QTY
4
1
1
2
2
6
1
1
4
4
2
4
2
2
DESCRIPTION
Screw
Gear Cover
Fixed Cover Rack
Bolt
Spring Washer
Washer
Rear Cover
Part Frame
Screw
Spring Washer
Snap Ring
Bearing
Wheel
Pine
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
EPT-2048-45 • EPT-2748-45
SPECIFICATIONS
4500 lbs.
3.1” - 8.2”
20”W x 48” L
27”W x 48” L
6.9”
24”
3.1” x 9.8”
3.25” x 4.5”
30”W x 78-1/2”L x 49”H
3.2 mph
3.8 mph
24V/1.2kw
24V/2.0kw
Micro-processors-MOS-FET-Controller
12x2V/160AH
25 amp
1012 lbs.
71.7”
LOAD CAP.
Loading Capacity
Fork Service Range
Fork Size (2048)
Fork Size (2748)
Fork Width
Load Center
Drive Wheel
Load Wheel
Overall Size
Walking Speed w/ Load
Walking Speed Unloaded
Drive Motor
Lift Motor
Controller
Battery
Battery charger
Weight w/ Battery
Turning Radius
Note: The load capacity is based on the situation when the
center of gravity is located at the center of the length of the
forks. When the load's center of gravity is past the center of
the forks, the load capacity will be lessened compared to
the center.
