midlandusa.com
5
English
François Español
Camera Mounting and Aiming
Mount on Dual Track System
The XTC280 was designed with an innovative identical dual track
mount system on both sides of the camera. This allows you to mount
it on either side of a helmet with ease. In addition, the interchangeable
mount piece can be moved from the helmet mount to the goggle mount.
This eliminates the hassle of having to remount the camera every time.
To mount the camera on the interchangeable mount piece, slide the
camera onto the dual track system with the two notches on the mount
facing toward the back of the camera.
To detach the camera from the interchangeable mount, hold the
camera with the lens facing away from you. Press down the mount
release switch and pull the mount toward you.
Dual Track
Mounting System
Mount Release
Switch
Interchangeable
Mount
Aiming the Camera when mounted with the dual track mount:
When mounting the camera on a helmet, you must do the following:
1. Consider what you would like to shoot and mount the camera
accordingly- left side, right side or top.
2. Find a at surface and ensure the area is clean of dirt and debris.
Remove the cover of the adhesive pad and adhere to the helmet.
3. Once attached, adjust the camera to be sure you are not lming the
sky or the ground.
Camera Mounting and Aiming
Mount using the Thread Mount
On the bottom of the XTC280 is a standard thread mount that allows
the camera to be mounted to a tripod or other xture with a 1/4-20 (1/4”
diameter, 20 threads per inch) 5/16 deep thread. For example, the vented
helmet strap mount is a screw type mount. To afx the camera, insert
the screw on the mount into the camera thread and rotate the camera
clockwise to tighten down onto the screw.
Over tightening may cause damage
to the mount and/or camera
Thread Mount
Screw Mount
Aiming the Camera when mounted with the thread mount:
When mounting the camera on the handlebars of a bike or with the
vented helmet strap mount, follow these steps:
1. Consider what you would like to shoot and mount accordingly.
2. Once attached, make sure that the camera is aimed straight and not
toward the ground or at the sky.
Reformatting the Micro SD card
Ensure battery is fully charged before formatting
The Micro SD card can be reformatted while in the camera. This allows
you to delete all the videos at one time. Follow these steps:
1. Move the RECORD switch to the Forward On / Record position.
2. When the battery indicator turns green, press and hold the Micro SD
card reformat button.
3. Keep holding the Micro SD card reformat button down until the record
indicator turns off and the Micro SD card indicator begins blinking
green.
4. Move the RECORD switch to the off position.
Note: The camera cannot reformat the Micro SD card if the low
battery light is on.
