A SERVICE OF

logo

Open as PDF
next previous
67
5. On the scanner that is the “Slave Unit”,
select
SLAVE
, then press
E
.
6. Press the SCAN key on both scanners. The data transfer is started from the Master Unit
to the Slave Unit.
During the data transfer, both scanners show
the following displays.
When the data transfer is completed,
COMPLETE
displays.
If the data transfer is not successful, the
following error message will appear.
Note: To clear
ERROR
, press .
To exit the clone mode, press the menu key repeatedly.
Note: Once you have completed the cloning of the scanners, reset by turning the scanners
off and then on again. This is particularly important to know if you wish to clone
another scanner right away.
BC780XLT1.qxd 10/08/2000 5:03 PM Page 67