A SERVICE OF

logo

MR-3018 DISASSEMBLY AND ASSEMBLY June 2005 © TOSHIBA TEC
4 - 24
4.4 Solenoid
[A] Original pickup solenoid (SOL1)
(1) Take off the original feed motor drive section.
( P.4-21 "[E] Original feed motor drive sec-
tion")
(2) Disconnect one connector. Remove 2
screws and take off the original pickup sole-
noid with the bracket.
Fig.4-66
(3) Remove 2 screws and take off the original
pickup solenoid from the bracket.
Fig.4-67
Note: Note:
When installing the original pickup solenoid,
be sure to align the edge of the original
pickup solenoid with the mark-off line on the
frame.
Fig.4-68
Original pickup solenoidConnector
Screw
Original pickup solenoid
Bracket
Mark-off line