A SERVICE OF

logo

4.25 Sound board/Microphone harness 4 Replacement Procedures
TECRA M10 Maintenance Manual (960-685) [CONFIDENTIAL] 4-75
Installing the Sound board/Microphone harness
To install the sound board/microphone harness, follow the steps below and refer to Figure 4-
47.
1. Connect the sound board FFC to the connector CN9630 on the sound board.
2. Connect the microphone harness to the connector CN6050 on the sound board.
3. Set the sound board/microphone harness to the slot and secure it with the following
screws.
M2.5×4B FLAT HEAD screw ×2
4. Stick the glass tape in place.