27
After system check completion, the Standby key changes from flashing to steady ON, allowing camera images
to be displayed.
Note
When the Recorder is used for the first time or when the power was switched off for a long period of time, the
date and time could not be correctly displayed. Perform the clock setting before use. (Refer to p. 14; "Clock
Settings.")
8. DIGITAL VIDEO RECORDER ACTIVATION AND TERMINATION
8.1. Recorder's Activation
The switch and key shown in the following figures are used in operation.
1. Connect each component correctly. (Refer to p. 40; "Connections.")
2. Set the rear-panel mounted Main Power switch to the ON position.
The Standby key flashes green for 5 seconds while settings are initialized. Thereafter, the Recorder is
placed in standby mode. The Standby key flashes every 5 seconds while in standby mode.
Note
Do not turn off the Main Power switch while the Standby key is flashing. Ensure that the Recorder is in the
standby mode when turning off the Main Power switch.
Logged data could be damaged or lost if the main power is switched off during initialization (while accessing
the hard disk).
3. Press the Standby key while the Recorder is in standby mode.
The screen automatically changes as shown below.
The Standby key flashes green during a system check.
