Toro 6500-D Manual

A SERVICE OF

next previous

Groomer

Reelmaster 6500--D/6700--D Groomer (Rev. C)Page 7.1 -- 13

Disassembly (Fig. 15)

1. Remove groomer height of cut assembly from cut-

ting unit (see Groomer Reel Removal in this section).

2. Disassemble groomer height of cut assembly using

Figure 15 as a guide.

Assembly (Fig. 15)

1. If bearing housing were disassembled, install bear-

ings and grease seals noting proper orientation of com-

ponents as shown in Figure 16.

2. Assemblegroomer heightof cut assemblyusing Fig-

ure 15 as a guide.

3. Install groomer height of cut assembly onto cutting

unit (see Groomer Reel Installation in this section).

4. Checkgroomerreelheightandmowerheight--of--cut

settings. Adjust as needed.

1. Drive side housing

2. Non--drive side housing

3. Grease seal

4. Grease seal

5. Bearing

6. Plug

7. Retaining ring

Figure 16

2

1

3

4

4

5

3

6

5

7