Adjustments Technical Manual LDK 20(S) - Studio Camera 4-3
Test Equipment
The following is a list of equipment required to carry out
the adjustment procedure:
• Set of board extenders LDK 4830/21
• Oscilloscope (with cursor measurement)
• Spotlight 3200K
• Gamma Test chart 4:3 / 16:9
• Waveform monitor
• Colour monitor
• Multimeter
• Master Control Panel LDK 4607 / LDK 4609
• Operational Control Panel LDK 4624 / LDK 4628 /
LDK 4629
• Audio Analyser
• Base Station LDK 4053
Set-up Instructions
Before carrying out any adjustments the following steps
are recommended:
• Install the camera on a tripod.
• Attach the lens and the necessary cables.
• Allow the camera to warm-up.
• Operate the camera in stand-alone mode
• Connect an MCP and OCP to the data connector on
the right connector panel of the camera.
• When the camera is used in the stand-alone mode,
MCP and OCP always operate in camera select
position 1 (OCP camera select switch in position 1).
CAUTION:
Do not attempt to improve camera performance
by adjusting individual potentiometers, jumpers or switches
as this may lead to complete misalignment of the camera.
CAUTION:
Do not realign individual potentiometers, jumpers or switches
not mentioned in this chapter or earlier in this manual.
These adjustment points are for factory use only.
CAUTION:
Switch off the power supply to the camera
before removing or replacing printed circuit boards.
