Part VI Sound
106
QQTG0701
Sound
Master Tuning
This setting is used to fine-tune the pitch of the entire instrument. This is convenient when this instrument
is played with other instruments or with a recorded performance.
1.
On the SOUND MENU display, select
MASTER TUNING.
• The display changes to the following.
2.
Use the
∧
and
∨
buttons to adjust the pitch.
Key Scaling
For each part you can change the tuning of each key within a one-octave range. In addition to equal tem-
perament tuning, you can perform in other types of scales, for example Arabic tuning.
1.
On the SOUND MENU display, select KEY
SCALING.
• The display looks similar to the following.
2.
Press the OCTAVE TUNING TEMPLATE but-
ton.
• The display looks similar to the following.
3.
Use the PART
∧
and
∨
buttons to select the
part to set.
• If ALL is selected, all the parts are set at once.
4.
Use the TYPE
∧
and
∨
buttons to select the
type of tuning.
• Select from FLAT, WERCKMEISTER, KIRNBERGER,
ARABIC 1 to 5, SLENDRO, and PELOG.
5.
Use the SHIFT
∧
and
∨
buttons to select the
key to perform in.
6.
Repeat steps 3 to 5 for each part, as neces-
sary.
7.
Press the SET button.
• The OCTAVE TUNING for the specified type and key is
automatically set.
■
■■
■ Settings for each key.
On the KEY SCALING display, you can adjust
the tuning for each key.
After selecting a key with the KEY SELECT
ᮤ
and
ᮣ
buttons, the pitch can be adjusted using
the TUNING
∧
and
∨
buttons.
• The pitch can be raised or lowered by a maximum of one
half-tone.
• You can use the PART SELECT
∧
and
∨
buttons to
switch the part.
• Use the ALL PARTS INITIAL button to return all parts to
the flat tuning.
Ⅲ
ⅢⅢ
Ⅲ
ORIGINAL tuning
Each instrument of each sound has its own origi-
nal tuning data. This setting affects the tuning
curve that spans the entire keyboard. So, for
example, the acoustic piano-type sounds dupli-
cate those of a real piano, in that the high notes
are tuned slightly higher and the low notes
slightly lower.
You can specify for each part whether this origi-
nal tuning is enabled or not.
1.
Use the PART SELECT
∧
and
∨
buttons to
select a part.
2.
Use the ORIGINAL TUNING ON/OFF button
to select ON or OFF.
11_Part VI.fm 106 ページ ２００３年５月１９日 月曜日 午後１時４４分
