Chapter 4 Setting Up ILOM 51
▼ Assign a Static IP Address to Server Module SP
Using the CLI
1. Connect and log in to ILOM as described in one of these procedures:
■ “Log In to ILOM Using a Serial Connection” on page 47
■ “Log In to ILOM From an Ethernet Connection Using the CLI” on page 48
2. At the ILOM CLI prompt (->), type the following command to set the working
directory:
-> cd /SP/network
3. Type the following commands, using your own addresses in place of the
examples below:
■ To configure a static Ethernet configuration, type:
-> cd /SP/network
-> set pendingipaddress=IP address
-> set pendingipnetmask=Netmask address
-> set pendingipgateway=Gateway address
-> set pendingipdiscovery=static
-> set commitpending=true
■ To configure a dynamic Ethernet configuration, type:
-> cd /SP/network
-> set pendingipdiscovery=dhcp
-> set commitpending=true
4. To log out of ILOM, type:
-> exit
