Reassembling the Computer
1 Tuck the cables behind the drives so that they do not come up above the
power supply.
Check the following before closing the computer:
● Are the connections between the drive and computer correct?
● Are the switches set to the appropriate positions?
2 Slide the computer’s cover on and fasten the cover mounting screws at
the back of the computer.
3 Remount the rear plastic panel, if any.
Installing the Drive Unit into the Computer 19
Mounting a Host Adapter
Install a host adapter in the computer by inserting it securely in a system
expansion slot. Refer to the operating instructions of the host adapter for
complete instructions on its installation and the assignment of its switches.
Note:
If you connect external SCSI device(s), you must remove a host adapter’s
terminator resistors.
18 Installing the Drive Unit into the Computer
