-15
Controlling the Projector via LAN
Controlling the Projector
Using Internet Explorer
(Version 5.0 or later)
Complete connections to external equipment
before starting the operation. (See pages 21-
25 of the projector’s operation manual.)
Complete the AC cord connection. (See page
25 of the projector’s operation manual.)
Note
•When connecting the projector to the LAN,
use a commercially available LAN cable
(UTP cable, Category 5,
cross-over type).
When connecting the projector to a hub, use
a straight-through cable.
1 Start Internet Explorer (version
5.0 or later) on the computer.
2 Enter “http://” followed by the
projector IP address set by the
procedure on page 14 followed
by “/” in “Address”, and then
press the “Enter” key.
•
When “DHCP Client” is set to “OFF” on
the projector, IP address is
192.168.150.2. If you did not change the
IP address in “3. Setting up a Network
Connection for the Projector” (pages
13-14), enter “http://192.168.150.2/”.
3 A screen for controlling the pro-
jector appears, ready for per-
forming various status condi-
tions, control, and settings.
After connecting the projector to your network, enter the projector IP address in “Address”
on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup
screen that will enable control of the projector via the network.
