Removing the stand
For wall mounting with the optional bracket, remove the stand.
Before detaching/attaching the stand
• Before detaching (or attaching) the stand, unplug the AC cord from the AC outlet.
• Remove all terminal covers and connected cables.
• Lay the TV down on cushioning (such as a blanket) over a table.
• Make sure two or more people perform the operation.
CAUTION
• Do not remove the stand from the TV unless using an optional bracket to mount it.
Preparation
Setting the TV on the wall
• You can mount the TV on the wall, using the optional AN-37AG2/AN-52AG1 bracket.
• For details, refer to the instructions supplied with the optional bracket.
CAUTION
• This TV should be mounted on the wall only with the AN-37AG2/AN-52AG1 (SHARP) wall mount bracket. The use
of other wall mount brackets may result in an unstable installation and may cause serious injuries.
• Installing the Liquid Crystal Television requires special skill that should only be performed by qualifi ed service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper
mounting or mounting that results in accident or injury.
<Example>
9
NOTE
• To attach the stand, perform the above steps in reverse order.
Hanging on the wall
AN-37AG2/AN-52AG1 wall mount bracket.
(See the bracket instructions for details.)
Vertical mounting
Angular mounting
12
Unfasten the four screws used to secure the stand in
place.
2
1
About setting the TV angle and height adjustment
1 0°/5°/10°/15°/20°
2 -5/0/+5 cm
(can be moved 5 cm
up or down)
AN-52AG1
For AN-52AG1
0°
AN-37AG2
Hex key
Detach the stand from the TV.
(Hold the stand so it will not drop from the edge of the
base area.)
PX5X_EN.indb 9PX5X_EN.indb 9 2007-5-9 11:43:152007-5-9 11:43:15
