29
Additional technical information
Particularities of operating mode 2:
In operating mode 2, the transmitter is not switched on by the sound
signal from the sound source.
To switch the transmitter on:
̈ Take the receiver out of the charging compartment.
To switch the transmitter off:
̈ Place the receiver into the charging compartment.
If – in operating mode 2 – you want to use a second receiver and charge
its rechargeable battery during operation:
̈ Pull the battery out of the receiver’s battery
compartment
8.
̈ Insert the battery into the charging
compartment
0 at the side of the trans-
mitter (see “Removing and charging the
receiver’s battery” on page 18).
̈ Slide the battery into the transmitter’s
charging compartment
0 as far as it will go.
