Richtdiagramm
90"
90"
250 Hzl_.-
500 Hz~
1000 Hz -
150"
150"
2000 Hz -
4000 Hz--
8000 Hz --
16000 Hz -.
180"
Frequenzkurve
Solifrequenzgang mitToleranzschema
Jedem Mikrofon legen wir das Original-Meßprotokoll bei,
gemessen von 50 . . . 20000 Hz.
MKH 416 T-3
Übertragungsbereich. .
AkustischeArbeitsweise.
40...20000 Hz
0ruckgradienten-Interferenz-
emptänger
Richtcharakteristik . . . . . . . . . . .. Superniere-Keule
Feld-Leerlauf-Übertragungsfaktorbei 1000 Hz20 mV/Pa:t1 dB
ElektrischeImpedanz bei1000 Hz. ca. 8..Q,symmetrisch,erdfrei
Nennabschlußimpedanz. . . . . . ;';;400.Q(200.Qbis 20 Pa)
Geräuschspannungsabstand nach
DIN45590, bezogen auf 1Pa
Aussteuerungsgrenze.
Speisespannung
Speisestrom. .
Temperaturbereich.
Stecker.
Beschaltung
Anschlußkupplung
ca. 72 dB
30 Pa (124 dB)
12V:t2V
ca. 6 mA
- 10° C bis + 70° C
3poliger Normstecker nach
DIN41524
1 :NF, 2 :Gehäuse, 3 : NF
nach DIN45595
3polige verschraubbare Norm-
kupplung nach DIN41 524,
z. B. T3261 001
19 mm <1>,235mm lang
160 g
MKH 416 TU-3
3poliger Cannon-Stecker XLR-3
1 :Gehäuse, 2 : NF,3 : NF nach
IEC-Normvorschlag
(Publication 268-14 B)
3polige Cannon-Kuppl. XLR-3-11C
19 mm <1>,250mm lang
175 g
Abmessungen
Gewicht
Abweichungen für
Stecker. . .
Beschaltung
Anschlußkupplung
Abmessungen
Gewicht
Änderungen,vor allem zum technischen Fortschritt, vorbehalten.
5
DIRECTIONALSTUDIO
MICROPHONE MKH 416 T
Oelivery: 1 microphone
GeneralDescription
The directionalstudio microphone MKH416Tis a transistorizedRF
condenser microphone.The oe voltage necessary foroperation is
fed through the conductors of the connecting cable (A-B powering
according to the German standard OIN 45595).
The MKH 416 T represents a combination of apressure gradient
transducer and an interference microphone. The directional
characteristic is super-cardioid at low and medium frequencies, at
higher frequencies the directional pattern is club-shaped. The
microphones susceptibility to wind and pop noises is low due to
the relative high acoustical membrane pressure. The MKH 416 T
can be employed as a microphone for soloists or for commentarv
purposes without using an additional popshield. However, for out-
door work the use of a windshield is recommended.
The frequency response is maintained to have a slight increase at
the high frequencies. The so-called close-miking effect is low with
this microphone. Therefore, the MKH 416 T gives a weil balanced
sound sensation even it is used close up.
Models
MKH 416 T-3 (Art.-No.1565)
12 V AB-powering,with 3-pin OINplug, screwable (OIN41 524).
Finish:mattblack.
MKH 416 TU-3 (Art.-No.1567)
12 V AB-powering,with 3-pin XLR-plug.Finish:matt black.
6
f- f-
-
==
110dB
-
--
f--
--t-
-=
=
t-
=
-
"
'" "'"
'00
""'"
-",
