Threading the Machine
• Threading the machine
* Raise the thread take-up lever to its highest position
by turning the handwheel counterclockwise, toward
you.
* Raise the presser foot lifter.
° Place a spool on the spool pin, with thread coming
off as shown.
[] Draw the end of thread around the upper thread guide..
[] While holding the thread near the spool, draw the
end of the thread down around the check spring
holder+
[] Firmly draw the thread up from right to left over
the take-up lever and down into the take-up lever
eye.
[] Slide the thread behind the needle bar thread
guide on the left.
[] Thread the needle from front to back or use a
needle threader.
• Drawing up bobbin thread
[] Raise the presser fool Hold the needle thread
lightly with your left hand and rotate the handwheel
countemlockwise, toward you, for one complete turn,
[] Bring the bobbin thread up by pulling the needle
thread up.
[] Pull both threads under and to the back of the
presser foot, leaving 4 to 6 inches (10 cm to 15 cm)
of thread clear..
[]
[]
[]
22
