A SERVICE OF

logo

3635
SYSTEM MAINTENANCE
ALARMS
The iDCS 500 system (with a LAN board installed) and the iDCS 100
Enhanced Software version system provide a feature that self-checks for
any failures. If a failure does occur in the iDCS software or hardware, a fault
error will be generated and buffered to an alarm report. During an alarm
state every phone with an assigned SYSTEM ALARM button will ring and
cause the SYSTEM ALARM button to flash amber. A phone with a display
should be used so that the alarm information can be viewed. When an alarm
occurs, the user can press the SYSTEM ALARM button to view and scroll
through the alarms. This will silence the audible part of the alarm, but the
SYSTEM ALARM button will continue to flash until your Service Company
views and clears the alarms in the alarm report located in the system soft-
ware.
ELBATWOLLANOITACOLERTESREMOTSUC
L/SNTB721CSB21DCL42CSB42DCLMOA23
SCDi&SCD
MOA46
B8SCDiB81SCDi
B81SCDi
SCDihtiw
MOA41
B82SCDi
B82SCD
SCDihtiw
MOA41
L/S
SEYONONONONONONONONONONONON
NTB7
ONSEYONONONONONONONONONONON
21CSB
ONONSEYSEYONONONONONONONONON
21DCL
ONONSEYSEYONONONONONONONONON
42CSB
ONONONONSEYSEYONONONONONONON
42DCL
ONONONONSEYSEYONONONONONONON
MOA23
ONONONONONONSEYSEYSEYSEYONSEYON
SCDi&SCD
MOA46
ONONONONONONONSEYONONONONON
B8SCDi
ONONONONONONONONSEYONONiONON
B81SCDi
ONONONONONONONONONSEYONSEYON
B81SCDi
SCDihtiw
MOA41
ONONONONONONONONONONSEYONON
B82SCDi
ONONONONONONONONONSEYONSEYON
B82SCDi
SCDihtiw
MOA41
ONONONONONONONONONONONONSEY
HOME PAGE
Table of Contents
Guide-Contents