15
MXP124/MXP124FX
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANO
Master Section
This following section details the master section of the mixer.
21. TAPE IN (RCA jacks) - Stereo line
level input, on RCA connectors,
for connecting the output of
devices such as MP3, CD,
computer sound-card, or any
other line level device.
22. TAPE OUT (RCA jacks) - The signal present at this connector is the MAIN
bus signal before it has passed through the MASTER level control and
graphic equalizer. The nominal output level is -10dBV and the impedance
is 100 Ohms.
23. MIX 2 - These line level MIX 2 outputs can be used to drive a second
speaker system or connect to a stereo device such as computer sound
card, MP3, or recorder. The signal at the MIX 2 jacks follows the MIX 2
level control knob allowing you to set a different level at the outputs.
24. MAIN MIX - The MAIN MIX ¼” jacks can be connected to a power
amplifier, powered speaker system, or inputs of a digital recorder. The
signal at the MAIN OUT jacks follows the MAIN volume fader.
25. FX SEND (MXP124FX) - The signal present at the FX
SEND output is sent from the FX bus, which is fed from
the FX send on the input channels.
MON SEND (MXP124) - The signal present at the MON
SEND output is sent from the MON bus, which is fed
from the MON send on the input channels.
26. PHONES Output - Connect standard ¼” TRS stereo headphones, 60 to 600
Ohms. The PHONES output level is controlled by the MIX 2/PHONES
control.
27. POWER Indicator - The POWER LED lights up to
indicate that the main POWER switch (located on the
rear panel) is on.
28. Output Level Meter - The output level meter allows you
to monitor the level of the signal, which is being sent
to the MAIN MIX jacks.
NOTE: To avoid distortion, adjust the MAIN MIX level
control so that the 0 indicator LED lights occasionally.
Top Panel Controls
21 22
23 24
25
26
27
28
29
