45
D. These lines indicate the “path” of the
cut (kerf) made by the sawblade.
E. When cutting the workpiece, line up
mark on workpiece with line on disk.
NOTE: When the blade is changed, or a
dado/molding head installed these lines
will need to be erased and reset.
12. Micro-Adjust Rip Fence...allows
the operator to accurately adjust the
rip fence using only one hand. To
move the fence push in on the micro-
adjust knob and rotate.
The microadjust mechanism may be
converted to operate on the left hand
side of the fence. Simply remove two
Phillips head screws - rotate the
micro adjust mechanism 180° and
reinstall screws.
13. Herc-U-Lift™ Caster Opera-tion
The caster set is activated by
pressing down on the metal platform.
This will raise the table saw and
allow the saw to be moved to desired
location.
To lower the table saw, press down
on the foot pedal. Make sure the saw
firmly rests on the floor. Adjust the
rubber leveling feet if necessary.
