Form Feed
101
4
Form Feed
This section gives instructions for op-
erating the machine when there is no
tray for the selected paper size or
type, or when paper loaded in the
machine has run out.
Limitation
❒ The tray cannot be changed if the
following functions are set for it:
•Staple
• Duplex Print to a tray that does
not support duplex printing
• Cover sheet
•Front and Back cover
• Slip sheet
Note
❒ If form feed is selected for a tray
with the following settings, you
can change the tray by canceling
the settings:
•Staple
•Duplex
❒ If Auto Continue is selected, form
fed paper is printed after a set in-
terval. See p.128 “System”.
If the machine does not have a tray for
the selected paper size or paper type,
or if the selected paper loaded in the
machine has run out, a caution mes-
sage appears.
If this message appears, do one of the
following:
Print Using a Selected Tray
A Select the tray for form feed from
those that appear on the display
panel.
If you want to print after adding
paper to the tray, select the tray af-
ter loading the correct paper.
Note
❒ To load paper in the bypass tray,
see p.13 “Setting Paper on the
Bypass Tray”.
B Press [Continue].
The machine prints using the se-
lected tray.
Note
❒ If a tray with a smaller paper
size is selected, the print job
may be cut short, or other prob-
lems may occur.
RussianC4EN-Print-F1_FM_forPaper.book Page 101 Wednesday, May 11, 2005 6:09 PM
