3 SpeedTouch™ Configuration Setup
E-DOC-CTC-20040123-0001 v3.0
27
7 The SpeedTouch™ Setup Wizard will search for the SpeedTouch™ on the net-
work. The following window shows the detection progress:
8 The SpeedTouch™ Setup Wizard should find your SpeedTouch™ device on the
local network. This is indicated by the following window:
If more than one device is found, a list of available devices will be provided. If this
is the case, select your SpeedTouch™ device (SpeedTouch™580) and click Next.
Note If the Setup wizard does not find any SpeedTouch™ on the network an
error window appears. In this case check that:
• The SpeedTouch™ is turned on and fully initialized.
• Your PC has a valid IP address (i.e. any IP address but 0.0.0.0).
• No dedicated firewall device or router is placed between your
PC and the SpeedTouch™.
• No personal firewall software is running on your PC.
Note It is possible that your PC isn’t correctly connected to the Speed-
Touch™580. In this case check that:
• The WLAN client is correctly associated with the Speed-
Touch™580 WLAN as described in “2.3.1 First-time Wireless
Client Association” on page 19.
• Your USB drivers are correctly installed if you are connected
through USB.
To repeat the search for your SpeedTouch™, click Back and proceed with
step 7 of this procedure.
9 Click Next to start the configuration procedure as described below.
