A SERVICE OF

logo

11. Determine the baud rate setting for the MIM by looking at the baud rate select
jumper on the inside of the door as shown below. Use the table below to determine
the selected baud rate of the MIM. The baud rate setting for an MDI application
can be determined from the existing configuration.
Jumper Baud Rate
E5 E4 9,600
E4 E3 1,200
12. Enter “1” to Set Baud Rate from the Main Menu.
From the Set Baud Rate Menu, enter a “6” - 9,600 or a “9” - 1,200 to match the
baud rate setting determined from the previous step. This baud rate setting will be
used to configure each radio.
Press ESC to return to the Main Menu.
Press ESC to Exit Setup.