9
NOTE : If the calibration distance is longer, the stride length will be more accurate as there
is more data available to calculate an average so the impact of anomalies is minimized. For
instance, the user can calibrate their walking stride length by using the 3D sensor to count
their steps over the course of a 10km walk-a-thon race and then divide the 10km by their
total steps. The 3D sensor will establish a more accurate pattern of the user's walk or run
hence the overall mean will be more accurate.
Chronograph Mode
Note: If you wish to use the heart rate feature, enter to the heart
rate sub mode and activate the heart rate feature before using the
chronograph mode.
1. Press mode/set key to enter chronograph .
2. Press start/stop/+ key to start the chronograph and step count function is enabled.
3. Press start/stop/+ key to stop the chronograph and step count function is disabled
4. Press and hold save/reset/- key to save the current exercise chronograph record into
memory
Press save/reset/- key to select " YES " or " NO "
Press and hold save/reset/- key again to confirm your setting ,
" OK " will appear if select " YES " and the current exercise chronograph record will save
into the memory and reset to zero. Chronograph record will cleared without saving if
select " NO ". Then the data saved can be transferred and uploaded to PC via the PC-
Link Software
5. Press save/reset/- key to toggle the different record on chronograph mode in the
following sequences:-
Clock Time - Heart Rate - Current Speed - Total Distance - Total Step - Total Calories
Consumption - Total Fat Burnt
CHRONOGRAPH MODE CHRONOGRAPH RUNNNG MEM STORED & CLEARED
