ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480. Assembly
requires two persons. Set the treadmill in a cleared area and remove the packing materials; do not dispose of the
packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking belt or to the
shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top
of the walking belt, wipe it off with a soft cloth and mild, non-abrasive cleaner.
Assembly requires the included hex keys and your own Phillips screwdriver , rubber
mallet , adjustable wrench , and wire cutters .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of the manual. The number after the parentheses
shows the quantity needed for assembly.
Note: If a part is not in the parts bag, check to see if it is preat-
tached to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic
parts, do not use power tools for assembly.
3/8" Nut (47)–4
3/4" Screw (2)–6
3/8" x 2 1/4" Bolt (40)–6
3/8" Washer
(33)–2
1/4" Star
Washer (21)–2
5/16" x 2 1/4" (20)–4
Wheel Spacer
(44)–4
1/2" Ground
Screw (11)–2
1/4" x 1/2"
Bolt (22)–4
Rack Bolt
(92)–2
3/8" Star
Washer (39)–4
5/16" Star
Washer (19)–4
3/8" x 2 3/4" Bolt (32)–2
1. Orient the Base (48) as shown.
Identify the Right Upright (36), which has a large
hole near the lower end.
Orient the Right Upright (36) as shown, and
attach it to the Base (48) with two 3/8" x 2 1/4"
Bolts (40) and two 3/8" Star Washers (39); do
not tighten the Bolts yet.
48
Large
Hole
40
40
39
39
36
1
6
