Black plate (63,1)
Switching the reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds.
1 Use MULTI-CONTROL to select
Reverse mode.
Reverse mode appears in the display.
2 Press MULTI-CONTROL to turn the re-
verse mode on.
ON appears in the display.
# To turn the reversemode off, press
MULTI-CONTROL again.
Note
You canalso turn on or offreverse mode by press-
ing BAND while thisunit is turned off. For more
details, see Reverse mode onpage 7.
Switching the Ever Scroll
When Ever Scroll is set to ON, CD text infor-
mation scrolls continuously in the display. Set
to OFF if you prefer the information to scroll
just once.
1 Use MULTI-CONTROL to select
Ever-scroll.
Ever-scroll appears in the display.
2 Press MULTI-CONTROL to turn the Ever
Scroll on.
ON appears in the display.
# To turn the EverScroll off, press
MULTI-CONTROL again.
Calibrating the RPMs
Follow the instructions below to measure the
RPM of your vehicle and records them. By
doing this, the tachometer of this unit can
work properly.
! Tachometer of this unit cannot work if you
do not perform the RPM calibration.
! In some vehicles, the tachometer may not
work properly even if you performed the
RPM calibration.
1 Park your vehicle in a safe place and be
sure to apply the parking brake.
2 Use MULTI-CONTROL to select
Calibration.
Calibration appears in the display.
3 Keep RPMs of the engine at 4000 rpm
and press MULTI-CONTROL.
To measure the RPM of your vehicle properly,
keep RPMs of the engine at 4000 rpm for a
few seconds.
When the RPM calibration is completed,
Completed is displayed.
# Some vehicles havea rev limiter that kicks in
early (e.g., 3000rpm) while parking. Inthis case,
perform RPM measurement at 2000rpm.
# To switch between 4000rpm and 2000 rpm,
push MULTI-CONTROL left or right.
<CRD4089-A/N>63
Initial Settings
En
63
English
Section
12
