44 Speaker Settings
The Player lets you adjust the speaker settings, volume balance, and delay
time for your audio system.You only need to adjust the speaker settings if
you used the Player’s MULTICHANNEL AUDIO OUT jacks to connect
the Player to a six-channel Receiver (Dolby Digital or DTS) as shown on
page 15.
1
Press SYSTEM MENU. will be selected.
2
Press 4 repeatedly to select G , then press 2.
3
Press 4 repeatedly to select Speakers, then press 2.
4
Press 3 or 4 to select the speaker you want to adjust, then
press 2.You can select Front L & R (left and right), Center, Surround
L (left), Surround R (right), or Sub Woofer.The speaker you selected
will be highlighted in the illustration at the right of the screen.
5
Press 2 or 1 to select B, , or X. Then,press 3 or 4 to
adjust the chosen setting.When you are finished,press OK
to go back and select a different speaker. Repeat steps 4-5 until
you are satisfied with all the speaker settings.
● Choose B to increase or decrease the volume of the speaker.
● Choose to adjust the frequency capabilities of your speakers.
Select L (large) if the chosen speaker can handle low frequency
signals below 120 Hz. Select S (small) if the speaker can not
reproduce low frequency signals below 120 Hz.Select c (off) if you
did not connect that speaker.Your choice will appear below the
bar at the bottom of the screen.See your speakers’ literature for
details on speaker capability.
● Choose X to adjust the speaker delay time.You can adjust the
delay time for only the Center and Surround speakers.
If the surround speakers are about 150 centimeters nearer to the
listening position than the front speakers, and the center speaker
aligns with the front speakers, no adjustment is needed.
If your speaker setup is different, adjust the delay times.First,
measure the distance, in centimeters,from the front speaker to the
listening position and from the surround speaker to the listening
position. Subtract the surround distance from the front distance, then
divide by 30.The result is the Surround speaker delay time in
milliseconds.
You may choose 0 ms,5 ms, 10 ms, or 15 ms in the X column for
Surround L and Surround R. Press 3 or 4 to choose the delay time
in the X column for Surround L and Surround R that is closest to
the delay time you calculated in milliseconds (ms).
Or,if the Center speaker is closest to the listening position,measure
the distance (in centimeters) between the Front and Center
speakers, then divide by 30.The result is the Center speaker delay
time in milliseconds. Press 3 or 4 to select this delay time in
milliseconds (ms) in the X column for Center.You may choose 1-5
ms.
6
Press SYSTEM MENU to remove the menus.
