STEP 20:Insert two 1/2" FLANGE BEARINGS
(34) into the LEG CUR/JEXTENSION
(6). See FIGURE 17.
STEP 21:Securely assemble LEG CURL/EX-
TENSION (6) to LEG FRAME (11)
using one 1/2 X 4" BOLT (22) and one
1/2" LOW HEIGHT NYLOCK NUT
(26). (NOTE: SECIYRELY TIGHT-
EN BOLT THEN BACK NUT ,OFF
1/4 TURN TO ALLOW THE PART
,
TO ROTATE FREELY.) See FIG-
[
~I/2X 4"
BUMPER (32) between the contact point
ofthe LEG CURL/EXTENSION (6) and I,G.UR
E
17
the LEG FRAME (11).See FIGURE 17.
STEP 23:Attach four ROLLER PADS (15) to the LEG CURL/EXTENS]:ON (6) using two
ROLLER PAD SHAFTS (13) and four STARLOCK COLLARS (35). See FIGURE
TI~IS CONCLUDES T_Wi~.~ ASSEMBLY
OF TIlE PARABODY 829102
LEG CURL/EXTENSION
FIGURE 18
1 [ I I0
[
I I II I .
I
3
I
9
