-37-
• When ON is selected for SUPER-D2 on the ALC
CONT menu
Notes:
• When ON is selected for SUPER-D2 in the ALC
CONT menu, FIX is not available for this item.
• When AUTO is selected for SENS UP and ON is
selected for SUPER-D2, the SENS UP function has
priority so that the SUPER-D2 function is not activat-
ed automatically.
• While the SENS UP function is selected, noise or
spots may appear in the picture when the sensitivity
of the camera is increased. This is a normal phe-
nomenon.
● Synchronization (SYNC)
Move the cursor to SYNC and select LL or INT with the
joystick.
Important Notices:
1. The priorities of SYNC modes are assigned as fol-
lows:
1. Multiplexed vertical drive (VD2) (highest priority)
2. Line-lock (LL)
3. Internal sync (INT) (lowest priority)
2. To use internal sync, select INT.
3. Whenever the vertical drive pulse (VD2) is supplied
to the camera, the camera sync mode is automati-
cally switched to the multiplexed vertical drive pulse
(VD2) regardless of the selected sync mode.
Line-lock Sync Mode (LL)
1. Move the cursor to SYNC and select LL with the joy-
stick. The LL sync mode is not available when the
multiplexed vertical drive (VD2) pulse is supplied.
2. After selecting LL, press the CAM (SET) key.
The SYNC menu appears on the monitor screen.
3. Supply the video output signal of the camera to be
adjusted and the reference video output signal to a
dual-trace oscilloscope.
4. Set the dual-trace oscilloscope to the vertical rate
and expand the vertical sync portion on the oscillo-
scope.
5. Move the cursor to COARSE with the joystick.
6. Match the vertical phases for both video output sig-
nals as closely as possible with the joystick. The
coarse adjustment can be performed in steps of
22.5 degrees (16 steps) with the joystick.
Note: After the 16th step, the adjustment level
returns to the first step.
7. Move the cursor to FINE by using the joystick.
