3-2. AGC detection control area setting (AGC CONT)
1. Set the ELC ON/OFF selector on the front panel of the
camera control unit to the OFF position. Then confirm
that the ELC parameter is OFF.
2. Move the cursor to the ELC parameter and press the
PAGE button.
The AGC CONT menu appears.
3. Follow step 3 descrebed for “3-1. ELC detection con-
trol area setting (ELC CONT)” to select the desired
detection area (AREA).
4. Follow steps 1 and 2 descrebed for “3-1-2. Peak and
Average Weight Control (PEAK/AVE)” to set the detec-
tion value.
4. Electronic Shutter Speed Setting
(SHUTTER)
Note: When ON is selected for ELC on the SETUP
menu, this item is not available. To select the elec-
tronic shutter speed, select OFF for ELC on the
SETUP menu.
You can select the electronic shutter speed of 1/100,
1/250, 1/500, 1/1 000, 1/2 000, 1/4 000 or 1/10 000 sec-
onds. The shutter speed can also be set manually.
1. Move the cursor to the SHUTTER parameter.
2. Select the shutter speed or MANU for manual setting
from the following.
3. When you have selected MANU, press the PAGE but-
ton. The SHUTTER menu appears and the MANU SET
parameter starts blinking.
4. Select the desired electronic shutter speed by press-
ing A or B. The adjustable range is 1/525-261/525
lines.
5. Gain Control Setting (GAIN)
You can set the gain (brightness level portion of an
image) to automatic level adjustment (AUTO) or manu-
al level adjustment (MANU).
Blinking
1. Move the cursor to the GAIN parameter.
2. Select AUTO or MANU. The gain of the video amplifier
is changed according to the position of the automat-
ic/manual gain selector (HIGH/LOW/OFF) on the front
panel of the camera control unit.
