A SERVICE OF

logo

Appendices
56
If possible, turn off the projector, then unplug the power cord and
wait at least 20 seconds before reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the “Replacing the Lamp” section
on page 59.
LED Problems
LED lighting message
Normal Operation
Message
Power
LED
L
a
mp-LED
Te
mp-LED
Red
Dark Blue
Bright Blue
Orange
Blue
Red
Blue
Standby State
(Input power cord)
Power on (warming)
Dark LED for cinema
(After Power on 5 mins.)
Power off (Cooling)
Blinking
Error (Lamp fail)
Blinking
Error (Fan fail)
Blinking
Error (Over Temp.)
Error (HDMI Connec-
tion Fail (*2))
Blinking
Error (RS232 Connection
Fail (*2))
Blinking
Steady light =>
No light =>
HD81’s Projector side
Normal Operation
Message
Power
LED
Red
Bright Blue
Standby State
(Input power cord)
Power on (warming)
HD81’s
Box