Advanced Settings
15
Setting Item Default Value Setting Details
Fixed Mode Off Specify an input signal when "HDMI",
"COAXIAL", or "OPTICAL" is selected for "Audio
Selector". Set this item if noise is produced, or
truncation occurs at the beginning of a track that
follows a gap when playing PCM or DTS sources.
"Off": To play an analog signal when there is no
digital signal.
"PCM": To fix the input source to PCM.
"DTS": To fix the input source to DTS (except for
DTS-HD).
Changing "Audio Selector" setting changes
"Fixed Mode" to "Off".
In the following cases, the settings for "Source Setup" cannot be changed:
㽎
When selecting the input selectors "AM" "FM" "USB" "BLUETOOTH".
10. Hardware (Hardware Setup)
Setting item Default Value Setting Details
Volume OSD On This function displays the volume level on the TV
screen during volume level adjustment.
"On": The volume level is displayed on TV screen.
"Off": The volume level is not displayed on TV
screen.
Remote ID 1 Select an ID for the remote controller to be used
with the unit from "1", "2", and "3", and set it to
differentiate this unit's remote controller from
those used with other Onkyo components when
multiple components are used in the same room.
If you change the ID on the unit, set the remote
controller ID to the same value accordingly to the
procedure below.
1. While holding down RCV, press Q SETUP
for about 3 seconds until the remote indicator
lights.
2. Press either 1, 2, or 3 using the number
buttons. The remote indicator flashes twice.
Setting item Default Value Setting Details
AM/FM Freq Step
(North American
and Taiwanese
models)
10 kHz/
200 kHz
Select the frequency step according to your area.
Select from "10 kHz/200 kHz" or "9 kHz/50 kHz".
When the "AM/FM Frequency Step (AM
Frequency Step)" setting is changed, all radio
presets are deleted.
AM Freq Step
(European,
Australian and Asian
models)
9 kHz Select the frequency step according to your area.
Select from "9 kHz" or "10 kHz".
When the "AM/FM Frequency Step (AM
Frequency Step)" setting is changed, all radio
presets are deleted.
Auto Standby On/Off This function places the unit on standby
automatically after 20 minutes of inactivity
without any video and/or audio input.
"On": To place the unit on standby automatically.
("ASb" flashes on the display.)
"Off": Not to place the unit on standby
automatically,
"Auto Standby" is appeared on the display
and menu screen 30 seconds before the Auto
Standby comes on.
"Auto Standby" does not work when Zone 2 is
active.
Default values vary depending on the regions.
HDMI Through Off Enables/Disables the "Auto Standby" setting
when "HDMI Through" setting is on.
"On": Enable this function
"Off": Disable this function
This setting is fixed to Off when setting "Auto
Standby" to "Off".
Version - The current firmware version is displayed.
Update via USB - Press ENTER to select when you want to update
the firmware via USB.
You will not be able to select "Update
via USB" if a USB storage device is not
connected or there is nothing to update in the
USB storage device.
