25
Adjusting the Tone
You can use the following buttons on the remote controller to adjust the tone.
Adjusting the Bass and Treble
1
Remote
controller
Press the [TONE] button to select
“BASS:0”.
2
Use the Up and Down [ ]/[ ] but-
tons to adjust the bass.
The default setting is “±0”. You can
adjust the bass and treble from –3 to +3.
Press [ENTER], and then use the
Up and Down [ ]/[ ] buttons to
adjust the treble.
Notes:
• If you press no buttons for 8 seconds, the
previous display will appear automati-
cally.
• If you press the [TONE] button while the
Direct function is on, the Direct function
will be turned off.
Using the Super Bass Function
Press the [S.BASS] button.
The S.BASS indicator lights up.
To turn off the Super Bass function, press
the [S.BASS] button again.
Note:
If you press the [S.BASS] button while the
Direct function is on, the Direct function
will be turned off.
TONE
S.BASS
MUTING
ENTER
/
DIRECT
S.BASS indicator
Using the Direct Function
Press the [DIRECT] button.
When the Direct function is on, the tone
controls are bypassed, so you can enjoy a
pure sound, and the DIRECT indicator
lights up.
To turn off the Direct function, press the
[DIRECT] button again.
When the Direct function is off, the tone
controls can be used to adjust the sound.
Muting the Sound
Press the [MUTING] button.
The output is muted and the MUTING
indicator flashes on the display.
To unmute the CD/HDD receiver, press
the [MUTING] button again.
Tips:
While the CD/HDD receiver is muted:
• Turning the [VOLUME] control on the
CD/HDD receiver or pressing the VOL
[ ]/[ ] button on the remote controller
will unmute the CD/HDD receiver.
• If you turn the CD/HDD receiver off, the
next time you turn it on, the CD/HDD
receiver will be unmuted.
DIRECT indicator
MUTING indicator
