35
Filter1 value: 2-256.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
Filter2 value: 2-256.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
Decimator: 1-1000.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
General Setpoint1.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
General Setpoint2.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
General Setpoint3.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
General Setpoint4.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
Output1 Mode 0=manual, 1=general setpoint.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
Output2 Mode 0=manual, 1=general setpoint.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
Output3 Mode 0=manual, 1=general setpoint.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
Output4 Mode 0=manual, 1=general setpoint.
Becomes effective only after a system reset (either
power off/on or using the ‘S’ command).
Baud rate for the RS232/RS485 port.
Possible values:
19200, 28800, 38400, 57600, 115200.
Note
The baud rate for the USB need not be defined –
its upper limit is 921,600.
