P/N 20-07121-00 Rev. C Page 9
5.11 Exit Program Mode “End”
Press the Enter key to exit Program Mode and return
to User Mode.
NOTE: To clear all values and restore factory
settings, press and hold the Scroll key
for two seconds, then press the Enter
key (while still pressing the Scroll
key). “FAC” will appear to indicate
that you have restored factory
settings and cleared the dispenser’s
memory (including counter reset to
zero). Press the Enter key again to
return to User Mode.
THEORY OF
OPERATION
MECHANICAL
INSTALLATION
ELECTRICAL
INSTALLATION
PROGRAMMING
USER MODE
OPERATION
TROUBLESHOOTING
SPARE PARTS
LISTING
MAINTENANCE &
SPECIFICATIONS
INDEX
Figure 5.0 Program Mode Screens
Lockout Period
Prime Pumps
Operating Parameters
Exit Program Mode
Clear Load Counter
Filter Duration
User Prime
Password Edit Password
Factory Reset
2 Sec
2 Sec
= Reset All
= on/off
Return to User
Formula Menu
Return to User
Formula Menu
2 sec
Flush
2 Sec
= Au (Automatic)
Minutes (00.0 = Lockout off)
Formula Program Pump Amount Seconds (Stopwatch Input)
Delay Time
Seconds (Minutes in Pb Mode)
Assign Pump (oc Mode only)
Return to Formula
Program Menu
Finish Program
Signal Occurrence
2 Sec
Seconds (1-19)
2 sec
2 sec
Selects Formula
Selects Pump Number
On = Minutes
2 sec
Pb (Push button)
oc (Occurrence)
r (Relay)
Set Value Screens
Enter Screen Set Value/Exit Screen
Changes Digit Value
Moves Blinking Digit (when applicable)
Figure 5.0.2 Set Numerical Display
Guide To Icons
Next key—moves
Scroll key—changes
Enter key—action
Gray (left) digit indicates blinking
Figure 5.0.1 Key Icons
