User Manual for the NETGEAR 54 Mbps Wireless PC Card WG511v2
4-14 Network Connections and Wireless Security
v2.2, December 2005
Setting up WPA-PSK Security
Follow the steps below to configure WPA-PSK Security.
1. Run the WG511v2 Smart Wizard.
a. Make sure the WG511v2 software is installed and the WG511v2 is fully inserted in an
available CardBus slot in your laptop computer.
b. Use the icon to open the Smart Wizard. The Settings tab page opens.
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
c. In the Security section, select WPA-PSK [TKIP].
For more information on WPA security, see the Web link to “Wireless Communications:”
on page B-1.
Figure 4-10
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.
