Mitsubishi Digital Electronics WL7050U Manual

A SERVICE OF

next previous

EN-24

8. ProjectorView

8.4. Setting the network password

(1) Click [PASSWORD] in the Setup window.

• Thewindowappearstoenterthecurrentnetworkpassword.

(2) Enter the current network password and click [OK]. (The default is "admin".)

• Ifthepasswordiscorrect,anotherwindowappearstoenteranewone.

• Ifthepasswordiswrong,anerrormessageisdisplayed.Whenyouclick[OK],thecurrentnetwork

password window reappears.

(3) Enter the New network password and Conﬁrm network password, and then click [OK].

• Ifpasswordsenteredmatch,thewindowclosestosavethechanges.

• Ifpasswordsentereddonotmatch,anerrormessageisdisplayed.Whenyouclick[OK],thenewnetwork

password window reappears.

8.5. Resetting the network settings

When you reset the network settings, all data and settings speciﬁed in 8.3. Entering projector information will be

reverted to factory defaults. Each ﬁeld will go blank, Alert e-mail service will be set to OFF, Language to English,

CerticationsettingtoON,andPasswordsettingto"admin".

(1) Click [RESET] in the Setup window.

• Thewindowappearstoresetthenetworksettings.

(2) Click [OK] to revert the network settings to factory defaults.

• Ifyouclick[CANCEL],thewindowcloseswithoutresetofthenetworksettings.