The wash programme stops and a fault indicator light comes
on.
Problem Possible cause Remedy A
The buzzer sounds and
the Drain check light
flashes. "– – –" appears
in the display.
The water outlet is
blocked or restricted.
Clean the drain filter and the
drain pump as described in
"Problem solving guide –
Opening the drum door in
the event of a blocked water
outlet and/or a power failure".
The drain hose has
been fixed too high.
The maximum drain height is
1 m.
The buzzer sounds and
the Water inlet check light
flashes. "– – –" appears
in the display.
The water inlet is
blocked or restricted.
Check whether
– the stopcock has been
opened properly.
– the inlet hose is kinked.
The filter in the water
inlet hose is dirty.
Clean the filter.
The buzzer sounds and
the Water inlet and Drain
check lights flash. "– – –"
appears in the display.
The Miele Waterproof
system has reacted.
Call the Service Department
The buzzer sounds and
the Pre-wash or the Rinse
hold Sequence indicator
light flashes. "– – –"
appears in the display.
There is a fault. Start the programme again.
If the fault message appears
again, contact the Service
Department.
A To switch off the fault message: Switch the washing machine off with
I-On/0-Off
button.
Cleaning and care
34
