&')+ &%
+$ *) '+ &%
1 Status LED indicates system status.
2
Digital Meter Display is a bright LED display of key welding information. Adjusting Parameter
Knobs.
3 MSP4 Panel is used to set the weld mode, adjust the arc, change arc start/end parameters
and for set-up information.
4 Cold Feed - Gas Purge Switch, press the switch up to feed wire with weld output off. Press the
switch down for gas flow with weld output off.
5 2 step - 4 step Switch is used to choose between a 2 step trigger or a 4 step trigger operation.
6
Location for Optional Memory Panel. (Order K2360-1 for the memory panel. See Accessories
Section).
7 Cover for Optional Water Cooling Kit, remove when the water cooling kit is installed. See
instructions with water cooling Kit.
8 Trigger Connector 5-pin amphenol for connecting the MIG gun trigger. See Installation Section
for detail.
'&.)S$* %#. ))
)&%+'%#&%+)&#*%&%%+ &%*
CASE FRONT CONTROLS
,)
