Owner’s Manual 17
Installation
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV’s COMPONENT (Y, P
B, PR) INPUT, RGB, HDMI1/DVI or
HDMI2 jack for video connections, depending on your set-top box con-
nector. Then, make the corresponding audio connections.
How to use
1. Turn on the digital set-top box. (Refer to the owner’s manual for the
digital set-top box.)
2. Use TV/VIDEO on the remote control to select Component 1,
Component 2, RGB-DTV, or HDMI1/DVI, HDMI2 source.
HDSTB Setup
HDSTB Setup
How to use
Insert the CableCARD
TM
TM
received from the cable service provider to
the CableCARD
TM
TM
slot of TV back panel.
If the pairing information about this TV and the CableCARD is auto-
matically displayed on the screen, contact with the cable service
provider.
Note :
• CableCARD
TM
TM
have the types of Motorola, Scientific Atlanta, SCM etc..
These 3 types of CableCARD
TM
TM
can be used for this PLASMA TV.
Caution: When removing the CableCARD
TM
TM
, do not
drop it as this may cause damage to the
CableCARD
TM
TM
.
or
