4. Install the server in a rack. See the Rack Installation Instructions that come with
the server for complete rack installation and removal instructions.
5. To attach peripheral devices and connect the power cords, see “Connecting the
cables.”
Attention: In a dc power environment, only trained service personnel other
than Lenovo service technicians are authorized to connect or disconnect power
to the dc power supply. See the documentation that comes with each dc power
supply.
Installing the cover
To install the cover, complete the following steps:
1. Place the cover-release latch 1in the open (up) position.
2. Insert the bottom tabs of the top cover into the matching slots in the server
chassis.
3. Press down on the cover-release latch to lock the cover in place.
4. Slide the server into the rack.
Connecting the cables
The following illustrations show the locations of the input and output connectors on
the front and rear of the server.
Front view
1 USB 5 connector
2 USB 6 connector
3 Video connector
Chapter 2. Installing optional devices 75
