Invacare PHWH93 Manual

A SERVICE OF

next previous

SECTION 6—FRONT RIGGINGS

Van Seat 20 Part No 1143195

Adjusting/Replacing Telescoping Front Rigging

Supports

NOTE:Forthisprocedure,refertoFIGURE 6.6onpage 21.

NOTE:Whenadjustingthetelescopingfrontriggingsupportdepth,ensurethefootplatedoesnot

interferewiththecasterwheelrotation.

NOTE:Telescopingfrontriggingsupportsmaybeextendedupto2‐inchesfromthewheelchair

framein1‐inchincrements.Thisadjustmentdoesnotaffectseatdepth.

NOTE:Wheninstallingthefrontriggingssupporttubes,ensurethatthehingepinsareonthe

outsideofthewheelchairfacingawayfromtheseatframe.

1. Removethetwosocketboltsandlocknutsthatsecuretelescopingfrontrigging

supporttotheseatframe.

2. Performoneofthefollowing:

•Adjusting‐Aligntheappropriatemountingholeofthetelescopingfrontrigging

supportwiththefrontmountingholeintheseatframetubestoachievethedesired

depthasshowninFIGURE 6.6.

•Replacing‐Performthefollowingsteps:

i. Removetheexistingtelescopingfrontriggingsupportfromthewheelchair

frame.

ii. Insertthenewtelescopingfrontriggingsupportintotheseatframe.

iii. Aligntheappropriatemountingholeofthetelescopingfrontriggingsupport

withthefrontmountingholeintheseatframetubestoachievethedesired

depthasshowninFIGURE 6.6.

NOTE:Thefootplatewillbeontheinsideofthewheelchairwhenlockedinplace.

3. Usingthetwosocketboltsandlocknuts,securethetelescopingfrontriggingsupport

totheseatframeasshowninFIGURE 6.6.

4. Ifnecessary,repeatSTEPS1‐3onremainingtelesco pingfrontriggingsupport.