English – 27
Maintenance
Assembly
1 Fit the front belt on the centre pulley. Pull it on the outside
of the runner wheel and on the inside of the idler pulley.
2 Fit the centre belt on the centre pulley.
3 Reset the cutting unit from service position to mowing
position.
Fitting the cutting head
1 Place the machine on a flat surface and apply the parking
brake. Check that the lever for setting the cutting height is
in the lowest position.
2 Push the equipment frame down and place the catch
against the frame.
3 Remove the drive belt and place it in the belt holder.
4 Push the deck in and put the front guide plugs in the
grooves on the equipment frame, one on each side.
5 Push the unit in so that the interior plugs touch the bottom
of the equipment frame’s grooves.
6 Lift up the cutting unit
7 Fit the drive belt around the drive wheels of the cutting
unit. Hook up the height adjustment strut.
8 Secure the collet spring.
Fit the front cover.
!
WARNING! Wear protective glasses when
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
!
WARNING! Observe caution to avoid
trapping your hand.
